Now, I find thtre are some trouble in my IPT in running process. The PSTN call can enter into MGCP gateway(I ckeck it through debug isdn q931),but the call can't go to CCM. I find the mgcp is deactive in MGCP VG(I check it through sh mgcp in mgcp VG). After I restart MGCP in VG through no mgcp then mgcp command, the question is solved. Why ? The question comes in the running process.
I'm not agree with mparekh. Because my MGCP VG is in remote office and the MGCP is deployed SRST. If the MGCP VG can't register with the CM, the SRST should work in and PSTN can go into remote office and remote office can't communicate with centre office.But now, the question is the PSTN can't go into remote office and the remote office can communicate with centre office. So I'm very confused.Why?
i may be incorrect but i believe the following commmand is missing :
To specify the time when control is to be returned to the primary Cisco CallManager server once it becomes available, use the ccm-manager switchback command in global configuration mode. To reset to the default, use the no form of this command.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...