Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP-SRST

Hello,

I am trying to expand the incoming number and add a prefix under srst configuration. I have the translation pattern applied on the pots dialpeer. Call doesnt seem to hit the dialpeer on inbound and hence the translation. Applied the TP on the voice port with same result. The test trasnslation rule shows correct results, adding the prefix. Any ideas ?

Applied translation profile on inbound side of the pots dialpeer.

Thank you,

4 REPLIES
Hall of Fame Super Gold

Re: MGCP-SRST

With MGCP, translations and DPs have no effect.

Cisco Employee

Re: MGCP-SRST

Are you trying to perform the digit manipulation when the router is registered as an MGCP gateway or when the MGCP endpoint

falls back into SRST mode?

-Felipe

New Member

Re: MGCP-SRST

In SRST mode.

Cisco Employee

Re: MGCP-SRST

Can you paste your Translation Profile and Translation rule config. Also, take following debugs to check which dial-peer is getting matched as inbound dial peer and if translation is taking effect.

debug voip ccapi inout

debug voice translation

362
Views
0
Helpful
4
Replies