We have a CCM 6.1(2) installation and are going to be adding a remote location using a 2800 ISR. We have a requirement to support four in-bound analog lines (DIDs). We'd like to make this 2800 ISR voice gateway MGCP controlled.
Does the VIC3-4FSX/DID module, configured as DID ports, support MGCP or does the gateway still have to be configured as an H.323 gateway.
Does anyone know when Cisco will be adding analog DID support for MGCP gateways?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.