I have a 2801 router and want to configure it for using QSIG. I am using MGCP. I tried a lots configurations in order to get the endpoints (VWIC2-1MFT-T1/E1) registered. But, I still see them unregistered on the call Manager (device --> Gateway).
But, if I make a "show ccm-manager hosts" I get the following message:
MU-GW-2801#sh ccm-manager host MGCP Domain Name: MU-GW-2801 Priority Status Host ============================================================ Primary Registered 172.17.7.5 First Backup None Second Backup None
It says registered. I do not know what am I missing. When I synchronize the gateway with the CUCM, the ".cnf.xml" is downloaded to the gateway and lots of lines are added to the running-config. But, it still says unregistered endpoints in the CUCM.
I think CUCM and Router are only about layer 3 relative. The CUCM backhaul the layer 3 info from router. The router will transfer the info of L1 and L2 back to the CUCM for it to make a decision. Even the router doesn't have L1 connectivity, it can still register with CUCM.
I did a lab today. I found the CUCM can register with my E1 PRI even the router 's isdn's layer 1 status is deactivated. So I think that means the layer 1 connectivity is not established. Does that mean my lab and your words has conflicts? Or I just misunderstand what you were trying to say?
These are the paths to get to each CCX logs through CLI. They may be helpful if you are having issues accessing RTMT or downloading logs through it.
If you want to download them you have to prefix "file get " and you can add one of the options (re...