Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP with server config and no dial-peers

Hi,

When mgcp config is downloaded from CCM, is there a need for the (pots) dial-peers anymore? The MGCP gateway is 3845 router with 12.4 IOS and the CCM has version 5.1. The router has eight T1 PRI ports (to PSTN) but the CCM has not created any dial-peers for the voice ports. Do I need to create them manually?

The calls from/to PSTN seem to be working (there are small issues though).

Thanks,

ioan

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: MGCP with server config and no dial-peers

PRI ports won't show up as dial-peers on the router.

Analog POTS FXO's and FXS's usually do have dial-peers like below:

dial-peer voice 999010 pots

service mgcpapp

port 0/1/0

!

4 REPLIES
Hall of Fame Super Red

Re: MGCP with server config and no dial-peers

Hi ioan,

One of the nice parts of using MGCP is that dial-peers are not required :)

How to Configure MGCP with Digital PRI and Cisco CallManager

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

Hope this helps!

Rob

New Member

Re: MGCP with server config and no dial-peers

Hi Rob,

Thanks for your reply. If I understand correctly, if ccm config is used AND if "isdn bind-l3 ccm-manager" is present under serial port, there is no need for dial-peer (which would bind the respective voice-port to mgcp).

However, from what I know, in all Cisco docs presenting "manual" mgcp config, the dial-peer(s) binding the voice-port(s) to mgcp is always present.

Please correct me if I'm wrong.

Thanks,

ioan

Silver

Re: MGCP with server config and no dial-peers

PRI ports won't show up as dial-peers on the router.

Analog POTS FXO's and FXS's usually do have dial-peers like below:

dial-peer voice 999010 pots

service mgcpapp

port 0/1/0

!

New Member

Re: MGCP with server config and no dial-peers

Thank you guys.

ioan

382
Views
0
Helpful
4
Replies