Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP

My client is using VG with IOS c2800nm-spservicesk9-mz.124-20.T1.bin. However, when i'm trying to configure MGCP, on the D Channel port, i cannot find the * isdn bind-l3 ccm-manager* command.

I only can find the following command:

KR-BSN-VG(config-if)#isdn bind-l3 ?

q931 Select IOS Q.931

As a result, i was forced to use H323 instead of MGCP. Is there any reason why??

Would appreciated if anyone can shed some light on this.

Cheers,

Hunt

1 REPLY

Re: MGCP

Hi Hunt,

If you do a 'show run | s controller' do you have 'pri-group timeslot 1-24 service mgcp', or are you missing the 'service mgcp' command?

If so, you will need to shut the voice ports, Serial interface, and controller down, remove the pri-group, and replace it with the above command.

I tested this in the lab and this is most likely the case.

hth,

nick

110
Views
0
Helpful
1
Replies