Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Microsoft Lync with CME 8.6

Hi voice team,

     I´d like to integrate my microsoft lync 2013 with my CME 8.6, using the same extension already configured on CME. How can i do that?

Thanks.

Thiago

Everyone's tags (2)
2 REPLIES
Cisco Employee

Microsoft Lync with CME 8.6

Hi Thiago,

It cannot be done with same extension, however can be with below scenario:

Below is the CME SRND showing "Configuring Single Number Reach"

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesnr.html#wp1015306

Let's say for example:

CME with IP phone has DN 1001

!

MS Lync client has the same extension 1001

Then, do-able with SNR on CME

i.e SNR # will be 551001, and either configure voice translation-rule on CME to strip 55 in the direction to Lync

OR

Create rule on Lync, and strip 55 before routing the call to Lync client with 1001

Hope the above helps.

Regards

Prashanthi Velpula

Microsoft Lync with CME 8.6

Hi Thiago,

Yes, you can integrate Lync 2013 with CME or CUCM using any planned extension on either end.

You need a site code to reach Lync user from CME following to their tel:XXXX, the translation rule in CME will strip off the site code before sending call via the configured SIP dial peer.

And in Lync, configure the Global dial plan "Normalization Rule" including the site code of CME users in front of CME users extension (Ex: Pattern to Match: ^(2\d{4})$   Translation Rule: $1) assume CME user extension is 1XXX, Lync user will dial 21XXX to reach CME users. The CME can strip the leading 2 from the incoming called number and connect a call to CME users.

Thanks

Selvarathnam

1284
Views
9
Helpful
2
Replies
CreatePlease login to create content