Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Migration from CMBE to Stand alone CUC and UCM

Is there any migration path from Cisco Unified Business Edition to Stand alone Unity Connections and Unified Communications manager? I have see bits and pieces but nothing definitive as far as migration process. I do know the Licensing will migrate so that is not my question. My question is specifically what if any tools are there to perform the migration so that it is not a complete rebuild, or is it a complete rebuild?

4 REPLIES
Cisco Employee

Re: Migration from CMBE to Stand alone CUC and UCM

Reusing the MCS-7828 After Installing Cisco Unified Communications Manager Business Edition

If you have installed Cisco Unified Communications Manager Business Edition on an MCS-7828 server, and you decide that you need to migrate to separate Cisco Unified Communications Manager and Cisco Unity Connection environments for increased scalability and capacity, you can reuse that MCS-7828 server to run Cisco Unified Communications Manager in a MCS-7825 cluster. Although you can reuse the server, you must reenter your data on the server manually. You must also obtain another server to run Cisco Unity Connection.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucmbe/install/7_1_2/cmins712.html#wp486077

You can use BAT for CUCM and COBRAS for CUC.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Bronze

Re: Migration from CMBE to Stand alone CUC and UCM

I am guessing this still applies and nothing has miraculously changed in version 8?

Cisco Employee

Re: Migration from CMBE to Stand alone CUC and UCM

Unfortunately you're right, nothing has changed, that info is still valid.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Migration from CMBE to Stand alone CUC and UCM

I had really good luck on a Migration I did by upgrading the CMBE to the exact version of CM I had installed on the new hardware, then do a BAT full export from the CMBE, clean it up as far as Service Parameters/Server/Unified CM etc. then apply my licensing to the new box and do the BAT Full Import

Some errors I ran into are you need to check the overwrite button or things like your default device pool will fail to import, also if you dont have your licensing in it wont let you import the phones (over the 50 demo DLU's)

620
Views
0
Helpful
4
Replies
CreatePlease to create content