Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

minimum multicast config for MOH

I have 6509 and 3750 switches and I am looking for the minimum configuration to get MOH to work for CM and phones. I can put "spare-dense" mode but am worried that dense will flood the network. Also I see that there are about 3 different pim-sparse options: ASM, SSM, BiDir.

1 REPLY

Re: minimum multicast config for MOH

ip multicast-routing

mls ip multicast

ip pim send-rp-announce loopback0 scope 10

ip pim send-rp-discovery scope 10

Router(config-if)# ip pim sparse-dense-mode

Sparse-dense will be fine, its standard practice... I run it everywhere...

HTH,

Chad

151
Views
0
Helpful
1
Replies
CreatePlease to create content