Mismatch language on a botom "back", provisioned for CUCM 7.1.5 to IPPhone 7965, 7945
I have an issue with follow equipments:
1.- CUCM 7.1.5 (Publisher and Suscriber)
2.- 7975 SCCP75.9-3-1SR2-1S
3.- 7965 SCCP45.9-3-1SR2-1s
I installed the locale file to change the language of IP Phone to Spanish , the file that i used is cm-locale-es-CO-220.127.116.110-1.cop (Spanish Colombia). The cop was installed succesful first in Publisher and then in Suscriber. Verifying the installation of language in IP Phones, I note that the only phone bottom that not change of language is "Back" in the route for example Directory-->Missing Calls.
I attached a picture of behaviour.
Somebody Knows if is possible to change the language of bottom "BACK" to spanish.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...