Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

missed call list

When I press "Directories" button, I can see the Missed Calls List. If I open the list and select one of the number, I can dial this number. But, can the system automatically add outgoing trunk access code, say "9" in front of the number?

3 REPLIES
Silver

Re: missed call list

yes make the discard digit (PreDot) in Called Party Transformations under Route Group level not under Route Pattern!

hth

/majdi

Silver

Re: missed call list

Hi Mike,

Not sure what CCM ver you are running.

Probably the nicest way is as follows.

Go to CCMAdmin > Service > Service Parameters for the callmanager services. Go to the advanced settings then have a look for the following parameters:

National Number Prefix

International Number Prefix

Subscriber Number Prefix

Unknown Number Prefix

You can put in your required access codes / prefixes for each number type and the system will then prepend them into the calling party numbers.

Heres a link with all the methods:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805b6f33.shtml#ccm1

Cheers,

Tim.

New Member

Re: missed call list

ccm version we're are using is 4.1(3), if service parameter can changed, then how to cater the centralized solution. it is because our ccm serve different countries and service parameters seems a systemwide parameters.

120
Views
0
Helpful
3
Replies
CreatePlease to create content