I have a client who is running a UC520 with 4 FXO ports. Unfortunatly I need to configure one of them and it appears to not br registering. I am running a fax machine off of the port and with a butt-set attached I can make out bound calls but inbound gives a busy. My questions is how do I register the port. Originally the port didnt even have a MAC or ephone configuration. Please see the info below.
UC520#show stcapp device summary Total Devices: 2 Total Calls in Progress: 0 Total Call Legs in Use: 0
Port Device Device Call Dev Directory Dev Identifier Name State State Type Number Cntl ---------- --------------- -------- ------------- ------- ----------- ---- 0/0/2 AN1EF790CA40002 IS IDLE ALG 236 CME 0/0/3 AN1EF790CA40003 IS IDLE ALG 226 CME
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...