we upgraded our Callmanager from 3.3(4) to 4.2(3). On the old system we had MLA installed and some groups configured.
After the upgrade I still have all the Functional Groops and all User Groups available. However I can not assign Privileges to User Groups since I don't have the Functional Groups listet on the right side of the Window. I can choos the user groups on the left but no functional groups.
Has anyone an idea, where else I can configure the MLA.
After upgrade to Cisco CallManager 4.1(x) from either Cisco CallManager 3.3(x) or Cisco CallManager 3.2(x) with MLA enabled, the password for the super user CCMAdministrator gets reset. At the end of the upgrade, a message box displays the new CCMAdministrator password. Use this password and change it to a unique value
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...