Silly question: Using Mobile Connect/Single Number Reach, how do you transfer a call?
Basic Single Number Reach is working. The *81 (Hold), *82 (Exclusive Hold), *83 (Resume) and *74 (Handoff) codes are working fine. But when I dial *84 (Transfer) either when in a call, or after a call has been put on hold, nothing happens. The *84 code is shown in Service Parameters as the code for Transfer.
Let's say a user (A) makes the initial call to the desk phone (RDP), which rings the cell phone too (Mobile Connect). The initial call is answered on the cell phone(C). The correct way to do DTMF transfer is when A talks to C, C needs to punch *82 to hold the call. Then C makes a new call to Enterprise Feature Access DN, once it shows connected (silently), punch in PIN#*84#tagretDN#. Target DN should ring and you can punch *84 again after talking to target or when target is ringing to complete the transfer.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.