I have configured Single Number Reach in CUCM 7.1(3). The Phone number of the calling party is not displayed in Received Call List in the following scenario. Is this a feature limitation or do we need to do any other configuration.
1. DN 2000 Calling DN 2001.
2. Call is picked up by the Remote Destination Number. ( Mobile Phone)
3. Call disconnected through nomal call clearing.
4. When we see the received called list in the DN 2001 there is no entry for the call.
Please let me know if this is a known limitation in CUCM or any solution for the received call entry.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...