Has anyone got mobile voice access working with a H323 gateway. I have configured it, but when I ring the DDI, the call hits the gateway and drops. I have attached my config below. My mobile voice access number is 53842 and the DDI is 9842
Calls for Mobile Voice Access through an H.323 IOS gateway do not work when Cisco MobilityManager is used. The problem in this case is that for every call that is made through the Cisco MobilityManager, the CallManager sends the same called number. When option 1 is pressed in order to make an outside call, the call is disconnected by the H.323 gateway after four seconds.
In order to resolve this issue, perform these steps:
Make sure the H.323 gateway has the VoIP dial-peer pointing to the Computer Telephony Integration (CTI) ports correctly.
Disable the H.323 gateway for Inbound FastStart in the Cisco CallManager administration.
Configuring H.323 Gateways for Mobile Voice Access:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...