I'm playing around with the mobility feature of CUCM (I'm on 8.6.2)
I can use the *81 & *83 codes to hold and resume a call. But how does the transfer *84 work ? I can't find any docs on how a user uses the mobility feature; Only docs on how a sysadmin sets it up in CCMAdmin !
Midcall Enterprise Feature Access Support Using DTMF—You can configure DTMF feature codes as service parameters: enterprise hold (default equals *81), enterprise exclusive hold (default equals *82), resume (default equals *83), transfer (default equal *84), and conference (default equals *85).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.