Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Mobility Manager1.2 - dial delay by route point !#

configured MM route point extension !# as per installation guide but it makes dial delay (15 sec inter-digt timeout) for all includes between IP phones. How can I resove this?

CCM5.0.4

Thanks in advance,

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Mobility Manager1.2 - dial delay by route point !#

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html

Hope this helps. If so, please rate the post.

Brandon

1 REPLY

Re: Mobility Manager1.2 - dial delay by route point !#

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html

Hope this helps. If so, please rate the post.

Brandon

96
Views
0
Helpful
1
Replies