Is there any way to change the amount of rings it takes for a cell phone to begin to ring when setting up Cisco Mobility? Currently it takes about 2 rings before our cell phones rings with mobility enabled. I was wondering if there was any way to change this to about 1 ring.
In addition to Java's response: Be aware that many cell phones have a delay before they start ringing which is beyond the control of CUCM. You can pin this down by watching your gateway/trunk to mark the time between when the SETUP/INVITE is sent and when the phone actually rings. Even if you set the Delay Before Ringing Timer to zero (0), you may still experience a ring or two worth of delay. Your only way to combat this is to raise the Call Forward No Answer timer on the DN and the Answer Too Late Timer.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.