Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Modify alphanumeric Sip Called Number

Hi everyone,

I'm trying to set up a sip connection between ITSP and my company. When I got incoming calls from PSTN to my online number this is showing a alphanumeric called number instead numeric as below:

May 18 14:33:29.248: //11085/45231A6AA411/SIP/Call/sipSPICallInfo:

The Call Setup Information is:

Call Control Block (CCB) : 0x485ED634

State of The Call        : STATE_DEAD

TCP Sockets Used         : NO

Calling Number           : 2721048092

Called Number            : companyname01

Source IP Address (Sig  ): 10.21.18.100

Destn SIP Req Addr:Port  : 201.86.87.2:5060

Destn SIP Resp Addr:Port : 201.86.87.2:5060

Destination Name         : 201.86.87.2

May 18 14:33:29.248: //11085/45231A6AA411/SIP/Call/sipSPIMediaCallInfo:

Number of Media Streams: 1

Media Stream             : 1

Negotiated Codec         : g729r8

Negotiated Codec Bytes   : 20

Nego. Codec payload      : 18 (tx), 18 (rx)

Negotiated Dtmf-relay    : 0

Dtmf-relay Payload       : 0 (tx), 0 (rx)

Source IP Address (Media): 10.21.18.100

Source IP Port    (Media): 18952

Destn  IP Address (Media): 201.86.87.2

Destn  IP Port    (Media): 13506

Orig Destn IP Address:Port (Media): [ - ]:0

May 18 14:33:29.252: //11085/45231A6AA411/SIP/Call/sipSPICallInfo:

Disconnect Cause (CC)    : 16

Disconnect Cause (SIP)   : 500

Question is, how I will route this call once the called number is alphanumeric?

Anyone else already fixed that?

Thank you and I really appreciate any help

Everyone's tags (2)
4 REPLIES
Cisco Employee

Modify alphanumeric Sip Called Number

I believe you can do URI based routing on your dial peers.  Make sure you define the URI.

Modify alphanumeric Sip Called Number

How I can do that?

Cisco Employee

Modify alphanumeric Sip Called Number

Hall of Fame Super Gold

Re: Modify alphanumeric Sip Called Number

You need to ask you ITSP to send a called number.

532
Views
0
Helpful
4
Replies
CreatePlease to create content