Re: Modify calling number sent for on cluster calls
Thanks for the response.
I have set up a translation pattern as suggested and placed it in a partition that appears before the one containing the called device DN in the CSS of the calling device.
When I configure the exact number of the called device (e.g. 201) in the translation pattern field and place a call to 201 the translation pattern is matched and the calling device presentation is modified as required.
However if I enter a wildcard in the transaltion pattern field (e.g. 2XX) and place a call to 201 the translation pattern is not matched. Instead the DN assigned to the called phone (201) which is in a partition listed later in the calling phones CSS is used instead.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...