Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

MOH CCM 4.1(3)

Hi

We have a CCM 4.x in our lab, change site and the MOH of telephony stop of the play. I restart de TFTP and MOH Server but nothing!

We are using CISCO2801 like MGCP gateway.

Thanks

Peterson

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: MOH CCM 4.1(3)

MoH by default does not support G729, but you can configure CallManager such that it can stream G.729 as well. To do this you need to go to Service Parameters for Ip Voice Media Streaming Application and for the field "Supported MOH Codecs ", check G729 along with G711.

Hope this helps

8 REPLIES

Re: MOH CCM 4.1(3)

Did you change ip address on your callmanager ?

Community Member

Re: MOH CCM 4.1(3)

Hi

No it's same.

The ccm is tftp server too(lab)

The telephony is registered, the calls is ok.

I create a connection by ISDN by Siemens and the telephony "see" the telephony of Siemens side, but when I press hold button, only a beep sound.

Re: MOH CCM 4.1(3)

make sure the MRGL, MRGs in use with the phones in question, have a MOH server listed.

Community Member

Re: MOH CCM 4.1(3)

Hi

See attachments

Thanks

Community Member

Re: MOH CCM 4.1(3)

Hi

See attachments 2

Thanks

Community Member

Re: MOH CCM 4.1(3)

Hi

See attachments 3

Thanks

Community Member

Re: MOH CCM 4.1(3)

Hi

I found the problem.

The MOH don't play in G.729, only in G.711.

I don't know why! The MOH Audio Source is ok to G.729.

Thanks

Gold

Re: MOH CCM 4.1(3)

MoH by default does not support G729, but you can configure CallManager such that it can stream G.729 as well. To do this you need to go to Service Parameters for Ip Voice Media Streaming Application and for the field "Supported MOH Codecs ", check G729 along with G711.

Hope this helps

155
Views
5
Helpful
8
Replies
CreatePlease to create content