Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

MoH not heard

I'm using CallManager 4.3(2)sr1c and a 2821 VGW with IOS 12.4(15)T9. The Music on Hold audio source is the server. No MRGs or MRGLs are configured. We mention the specific music to be played on the line and on the phone. We have centralized CallManager with remote site that don't have a server onsite. At our remote sites we can hear music on hold when we call internal numbers, but people who call us from an external number only hear tone on hold. We want music on hold everywhere. We are running unicast music, and there are no ACLs on any ports between the server and the remote site. Ideas?

5 REPLIES
Bronze

Re: MoH not heard

Try to check the IPVMS service parameters

New Member

Re: MoH not heard

I did that and there wasn't much to see. We use G.711 a-law and it was there along with u-law and G.729. Flags set to true. Not a lot going on. Anything else?

Bronze

Re: MoH not heard

Try to add command ip multicast-routing

let me know if this works,

Bronze

Re: MoH not heard

you mentioned you using unicast,

add MRGL to the Gateway and reset Gateway should fix the problem

New Member

Re: MoH not heard

I had already done the MRGL thing. What finally fixed it was looking at the call when it was going out my router. A codec of G.729 was being negotiated. When we forced G.711 on the dial-peer, it magically happened.

171
Views
0
Helpful
5
Replies
CreatePlease to create content