06-03-2014 03:44 AM - edited 03-16-2019 10:58 PM
Hi to all,
I have a router Cisco 2801 (is a lab scenary) configured as call control. I have configured a CME 8.0. All is working properly but when I put a call waiting with an analogue phone connected to an ATA, MoH works fine but when I put the call waiting with a 7911 IP phone, the MoH isn't ear in the other peer.
Any Idea?? Seems something about DSP but, why works when I hold the call with the ATA??
The two types of phones are configured by the same mode. Tell me if you need something about.
Thanks for your help.
06-03-2014 06:20 AM
Hi,
May you please attach the out put of show voice dsp group all, show voice dsp detail for a working and non working call along with the output of debug ephone moh and debug voice ccapi inout for both the calls along with the calling, called and the party which pressed the hold key. Also send me the show tech from the router
Regards
Himank
06-03-2014 12:52 PM
You have to use multicast MOH for CME IP Phones. Can you attach your full running config?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide