Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

MOH on CUCME

I install and configure a new CUCME 8.6 on a 2951 router. The MOH is not working for internal and external calls.

My question is do i need to configure the ip pim dense on the router and switch? Is mandatory?

My config of MOH:

telephony-service

moh flash:/CME/music-on-hold.au

multicast moh 239.10.16.4 port 2000

Im using this guide:

http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucme/admin/configuration/guide/cmemoh.html#wp1021176

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

MOH on CUCME

You don't need to configure anything.

The default works fine.

6 REPLIES
Hall of Fame Super Gold

MOH on CUCME

You don't need to configure anything.

The default works fine.

MOH on CUCME

Paolo i dont nee to config the multicast too correct?

only the moh music-on-hold.au under telephony-service..

Thanks

Hall of Fame Super Gold

MOH on CUCME

Correct.

MOH on CUCME

Thanks i´ll try this tomorrow and i´ll let you know!

MOH on CUCME

Thanks Paolo

I put the default command, my moh file is under this directory that i create (/CME)

moh flash:/CME/music-on-hold.au

And the MOH is working!

Thanks!

Hall of Fame Super Gold

MOH on CUCME

You're welcome, thank you for the nice rating, and good luck!

432
Views
0
Helpful
6
Replies
CreatePlease login to create content