Scenario. Central call processing with Call Manager 6.0 and remote sites over a point to point. Calls from remote sites go out voice ports on their local routers for standard analog lines. Is there anyway to monitor and get notified if the analog lines are down? or the voice ports are not functioning properly? I know we can monitor the router itself in LMS but I don't think LMS will monitor the actual voice ports.
the SNMP should just report on hardware. I believe if you have ground start start lines on the FXO of the router, those will signal drops, but regular loop start will not. (Ground start looses ground, drops the connection and you get a busy signal)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.