Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring DSP resources, SNMP OID

Hi again, cisco gurus!

Have been looking for SNMP OID that allows to monitor the number of DSP-channels active on Cisco router for some days.

Has someone investigated this task? completely perplexed

thanks,

Boris Borodin

3 REPLIES
New Member

Re: Monitoring DSP resources, SNMP OID

Check out this link

http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_dsp_notifications.html#wp1054016

Also some additional information --

  • dspu—Sends a notification whenever the operational state of the physical unit (PU) or the logical unit (LU) changes or activation failure is detected. This is from the CISCO-DSPU-MIB, and the notifications are:

    enterprise 1.3.6.1.4.1.9.9.24.1.4.4

    1newdspuPuStateChangeTrap

    2 newdspuPuActivationFailureTrap

    enterprise 1.3.6.1.4.1.9.9.24.1.5.3

    1 newdspuLuStateChangeTrap

    2 dspuLuActivationFailureTrap

  • dsp—Sends a notification whenever the DSP card goes up or down. This is from the CISCO-DSP-MGMT-MIB, and the notification is:

    enterprise 1.3.6.1.4.1.9.9.86.2

    1 cdspMIBCardStateNotification

  • Also you could check out these two MIBS, from website http://www.cisco.com/go/mibs

    CISCO-DSP-MGMT-MIB

    CISCO-DSP-MGMT-CAPABILITY-MIB

    Hope that helps,

    CM

    New Member

    Re: Monitoring DSP resources, SNMP OID

    Hi! I have similar question.
       I have 2811 that uses like onramp/oframp fax-server.
        I need to monitor number of faxes that DSP is operates in time. I want make some graphs (in cacti or MRTG) that show load dsp
        resources by faxe's for optimizing number of DSP card in router and monitoring  max fax load time.
        I search in MIB but couldn't find strict that i want.
        May be you have some solution for such kind of question.
    Tank you.

    Re: Monitoring DSP resources, SNMP OID

    Medvec_Rc

    I have the some problem? Can you resolved it?

    I have 2811 that uses like fax onramp, and need the number of fax is received at time.

    Who can helpme.

    2206
    Views
    0
    Helpful
    3
    Replies