I have a working setup with CME8, BLF fields are setup and working fine, except the fact that BLF cannot differentiate between ring and talk states of the monitored DN. In both cases the BLF indicator is red, the little icon shows "off hook" state. This is quite annoying as there is no way to know if that phone is ringing or in use.
I read about BLF Pickup functionality which seems to support exactly that but it seems to be limited to CUCM only.
Is there a way to make the BLF lamp blink amber when the associated phone / dn is ringing within CME?
Just wanted to check if you have managed to find out a workaround.
My problem is we have 7916-24 Module on 7975 Phone. The operator should know before forwarding the calls if the destination phone is busy or free, now the operator is forwarding the calls to the phones and few of the managers are getting irritated with this, they want the operator to know if they are busy OR free..??? any comments plzz
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...