Moving Side B of IPCC 6.0 to a seperate building for DR purpose
I am running a duplex IPCC 6.0 with CCM 4.0.2a. Currently both side A and side B are on the same network (Subnet). I am looking into moving side B to our DR location in Texas and the IP addresses of side B will be changed to the network in Texas. I need to know what changes in IPCC I need to make to accommodate the IP address change on side B.
Side B consists of:
I have a single CCM cluster with CallManager already up running in Texas.
Has anyone done this before ? I know there are people out there that are doing this kind of setup.
Any help would be highly appreciated !!!! thanks in advance !!!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...