We recently added a remote site to our CCM and the call control seems to be delayed about 1-2 seconds before audio starts. I have verified that the QOS is being passed all the way to the routers serial interface.
But on the router I am seeing packets matching CS3 and AF31 is this normal?
(Switches are set for trust DSCP for CCM and Router)
On the MPLS network they are expecting precedence 3, what is the recommended method of marking this traffic for call control?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...