Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple DNs 7911 CM 6.1

We are running CM 6.1 and I am wondering if its possible to configure a single line phone to accept more than one DN. I don't want to share a line, but just the DN. I keep finding CME information about "Shared Ephone DN" and that sounds like what I want, but I am not running CME. So basically I want a single line phone to ring for more than one extension.

1 REPLY
Hall of Fame Super Red

Re: Multiple DNs 7911 CM 6.1

Hi Ben,

Nice to see that you got the Licensing issue worked out :) In CCM you could create a CTI RP that points (via Call Forward) to the existing 7911 DN.

So, if the 7911 had DN 5530 and you also wanted the same 7911 to have DN 8888 ring there. Provided 8888 was not on any IP Phone or device you could create a CTI RP for 8888 that routes to 5530 via Call Forward All.

This is one method. Hope this helps!

Rob

124
Views
0
Helpful
1
Replies