I need to configure two e1 isdn trunks on the same H323 gateway, running UCM 7.1. I can't bundle the links here as the service provider does not support bundling. each trunk has its own range of DID numbers therefore i need to treat them seperately. also i need all users to get access to the pstn using a single access code of 9, regardless of which trunk line they are going out through, any idea how i can achieve this ?
Thanks for the response, the issue is that at the gateway level i have the two outgoing dialpeers defined, one for each trunk. for example the first dialpeer has a destination pattern match of 91T and the second one has 92T.
my problem is to route the calls to the gateway from the call manager with the two seperate access codes for the same dialed number. for example if a phone has two lines, the first line (DN) is supposed to use the first trunk and the second line is supposed to use the second trunk for its outgoing calls, when the user dials a number example 9 030 2211411, i need to transform this number into 91 030 2211411 if he uses line 1 and transform the number to 92 030 221411 if he uses line 2. this way i will be able to send the calls to the gateway using the appropriate access codes
My problem is how to achieve this by minimizing the configuration within UCM.
Unfortunately UCM has no way of tranforming the dialed number based on the extension (not the device) the person is call from.
I dont know wether something can be done at the gateway level, by using the calling number.
I am hoping someone has come across such a scenario in the past.
Thanks a million, this sounds more like the right solution. I am using a lot of translation patterns to globalize all the dialied numbers, therefore option 1 will make the UCM config a bit complicated. Option 2 sounds more like it, will try them out and get back in a couple of hours.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...