Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple outgoing E1

I have a 2800 gateway configured for the moment with one outgoing/incoming E1.

The configuration is a dial-peer pointing to a voice port. My voice-port is configured as follow :

voice-port 0/0/0:15

translate calling 10

cptone FR

bearer-cap Speech

I will add another E1 for the same dial-peer. As it's not possible to add two voice port for a dial-peer I tried to create a trunk-group under the voice-port but I have the following error :

C2821CCM(config-voiceport)#trunk-group 1

Error: Failed to add non-analog port to trunk group

Configure in cas-custom mode or serial interface

mode for T1/E1 digital ports and in BRI interface

mode for BRI voice ports

Creating the trunk-group under Interface serial prevent me to use the confiugration under the voice port (especialy cptone FR)

What is the best practice for trunk-group and how could i creat a trunk of voice-port ?

Thanks in advance

1 REPLY
Hall of Fame Super Gold

Re: Multiple outgoing E1

Hi,

in fact trunk membership for PRI is configured in the serial interface. Just leave the options you need in voice-port and it should work fine.

Please remember to rate useful posts!

454
Views
0
Helpful
1
Replies
CreatePlease login to create content