I need urgent help, we have multisite deployment with centralized call processing system. Lets say we have 2 sites Site A and Site B.
Site A = 8994999
Site B = 44102111
TeHO is already configured. When i dial mobile in site B area then i will dial as 900<country code><44102111> it goes to site B gateway and then that mobile number. But the display number will be site B . How can i change the calling number ?
At what level do you have configured the calling party number??
Also, a lot of telcos won't allow you to send something that does not belong to the DID range you own and will overwrite it with the main DID. Have you confirmed that's not the case and you're allowed to send anything as calling party??
You will have to check with your TELCO if they allow any calling number or they allow only the range which they have given for that ares. Most of the TELCO will not allow other region number to be displayed when calling from other region.
Rate helpful posts by clicking stars below the answer.
Rate all helpful post by clicking stars below the answer.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.