Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Music on hold issues CUCM 7.0

I am trying to Integrate Cisco CallManager and Cisco SRST to Use Cisco SRST As a Multicast MOH, however when i enable muticasting on the MOH audio source coniguration page, the MOH stops playing on all location including the local site. what am i doing wrong..

3 REPLIES

Re: Music on hold issues CUCM 7.0

First. Can you route multicast in your network?

Second if you can. Check TTL value in MOH settings. TTL 2 will allow to pass 2 hops for multicast packets.

New Member

Re: Music on hold issues CUCM 7.0

Muiticast routing is not enabled on the network. I'll configure multicast Thanks a lot.

New Member

Re: Music on hold issues CUCM 7.0

Make sure your router configurations has these commands in it and that the ip address in your call-manager-fallback section matches what is configured for your MOH ip address in CUCM and make sure you have a loopback address configred for MOH as well.

application

global

service alternate default

interface Loopback0

description Used for Music ON Hold

ip address 10.10.240.107 255.255.255.255

ccm-manager music-on-hold

call-manager-fallback

max-conferences 8 gain -6

transfer-system full-consult

limit-dn 7940 2

limit-dn 7960 2

ip source-address 10.138.207.65 port 2000

max-ephones 42

max-dn 96 dual-line

transfer-pattern 8626250..

transfer-pattern 250..

translate called 10

moh Frischkorn.ulaw.wav

multicast moh 239.1.1.1 port 16384 route 10.138.207.65 10.10.240.107

Note in my example that the multicast moh ip is what should match your cucm ip, the port also has to match and the router would be your voice sub-interface via your loopback interface. Also make sure the moh file is on the flash card of the rotuer and that the name of the file is exactly the same in your call-manager-fallback section.

229
Views
9
Helpful
3
Replies
CreatePlease login to create content