Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mwi config question

Hi,

I'm trying to establish communication for MWI between CUE and CCME on UC520 system.

I understand theres 3 ways to accomplish this, but I only want to get this working using either "unsolicited notification" or "outcalling".

I've done the following configuration:

sip-ua mwi-server ipv4:CUEipAddress expires 3600 port 5060 transport udp unsolicited

ephone-dn 55

number 801... (using 3 digit extensions)

mwi off

ephone-dn 56

number 800...

mwi on

The CUE configuration is sync'd with the CCME.

I've tried debug ccsip messages and got no output.

When I type show sip-ua mwi, it doesn't display an output like this:

endpoint 800 mwi status ON

endpoint 800 mwi status ON

endpoint 801 mwi status OFF

I've looked at both articles in URL's below. I'm not quite sure if I'm missing soemthing simple such as a dial-peer to send the mwi message.. or something else. Any help is appreciated.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_configuration_example09186a008037f2a9.shtml

http://www.cisco.com/en/US/docs/ios/voice/sip/configuration/guide/sip_cg-mwi.html

TIA,

-Fred

206
Views
0
Helpful
0
Replies
CreatePlease login to create content