My client just installed a brand new CME with CUE on a Cisco 3945 ISR G2 router. However, they have over 30 Analogue phones which are connected to 2 x Cisco VG224, which in turn is registered with CME.
They have the following enquiries:-
Q1. Can analogue phones get MWI? Is there a particular brand / model of analogue phones that supports MWI?
Q2. If so, does MWI for analogue phones works with Cisco CME and CUE?
Thanks so much and would greatly appreciated if anyone can shed some light on this.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...