Thanks in advance to everyone
I still cannot get the VM light to light up. I can dialing the MWI number 8000 and off dialing 8001. Here is the configs from both (with some info removed).
This is the CCME router
isdn switch-type primary-ni
!
!
voice call carrier capacity active
voice rtp send-recv
!
voice service voip
h323
sip
!
!
controller T1 1/0
framing esf
linecode b8zs
pri-group timeslots 13-24
gw-accounting syslog
!
!
!
interface Serial1/0:23
no ip address
no ip redirects
no ip unreachables
no logging event link-status
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
!
router eigrp 100
network x.x.0.0
auto-summary
!
ip classless
!
ip http server
ip http path flash
!
!
control-plane
!
voice-port 1/0:23
!
dial-peer voice 100 pots
description inbound and outbound to PSTN
destination-pattern 9.T
direct-inward-dial
port 1/0:23
!
dial-peer voice 8991 voip
description CUE Voice Mail System
destination-pattern 8991
session protocol sipv2
session target ipv4:x.22.12.250
dtmf-relay sip-notify
codec g711ulaw
no vad
!
dial-peer voice 8010 voip
description AtuoAttendent_recoreded message
destination-pattern 8010
session protocol sipv2
session target ipv4:x.22.12.250
dtmf-relay sip-notify
codec g711ulaw
no vad
!
dial-peer voice 8011 voip
description AutoAttendent
destination-pattern 8011
session protocol sipv2
session target ipv4:x.22.12.250
dtmf-relay sip-notify
codec g711ulaw
no vad
!
dial-peer voice 8000 voip
destination-pattern 8000....
session protocol sipv2
session target ipv4:x.22.12.250
dtmf-relay sip-notify
dial-peer voice 8001 voip
destination-pattern 8001....
session protocol sipv2
session target ipv4:x.22.12.250
dtmf-relay sip-notify
no vad
!
gateway
timer receive-rtp 1200
!
sip-ua
mwi-server dns:voicemail expires 3600 port 5060 transport udp unsolicited
!
!
telephony-service
load 7910 P00403020214
load 7960-7940 P00308000700
load ATA ATA030100SCCP040211A.zup
max-ephones 52
max-dn 200
ip source-address x.16.11.254 port 2000
caller-id block code *67
timeouts interdigit 3
timeouts ringing 30
system message Welcome Todd
url services http://x.16.11.253/voiceview/common/login.do
url authentication http://x.16.11.253/voiceview/authentication/authenticate.do
time-zone 8
create cnf-files version-stamp 7960 Sep 12 2007 11:47:42
voicemail 8991
mwi sip-server x.22.12.250 transport udp port 5060 reg-e164
mwi expires 86400
max-conferences 8 gain -6
call-forward pattern .T
moh music-on-hold.au
dn-webedit
time-webedit
transfer-system full-consult
transfer-pattern 8...
transfer-pattern 111.
login timeout 600 clear 01:00
!
ephone-dn 180
number 7999
!
!
ephone-dn 190
number 8000.... secondary 8001....
mwi on-off
!
This is the CUE router
voice service voip
h323
sip
!
interface Loopback0
no ip address
!
interface FastEthernet0/0
ip address x.16.11.253 255.255.255.0
!
!
interface Service-Engine1/0
ip address x.22.12.254 255.255.255.0
ip route-cache flow
service-module ip address x.22.12.250 255.255.255.0
service-module ip default-gateway x.22.12.254
!
ip route x.22.12.250 255.255.255.255 Service-Engine1/0
ip http server
!
dial-peer cor custom
!
telephony-service
load 7910 P00403020214
load 7960-7940 P00303020214
load ATA ATA030100SCCP040211A.zup
max-ephones 48
max-dn 192
ip source-address x.16.11.254 port 2000
ccn application ciscomwiapplication
description "ciscomwiapplication"
enabled
maxsessions 8
script "setmwi.aef"
parameter "CallControlGroupID" "0"
parameter "strMWI_OFF_DN" "8001"
parameter "strMWI_ON_DN" "8000"
end application
Thanks
Todd
