We tried to accomplish QSIG integration over PRI's between CS1K and Cisco. Everything works fine except the MWI relay over QSIG across PRI's. Is there something that i missing in the integration piece. Here is the call flow. Our CS1Ks are at Release 7.65 with SP8 and CUCM at 10.5. What i am trying to accomplish is move the mailboxes for avaya phone to unity mailbox and be able to provide mwi to avaya phone from unity connection.
attached is the debug from the mgcp gateway. Our PBX tech has set up QMWI Integer Coding for the MWI and he complains that he doesn't see a message request rather a normal call for MWI. I believe that is norm and MWI is provided by Unity based on the bearer capability.
DCH 220 UIPE_IMSG CC_SETUP_IND REF 00002080 NCALL TOD 11:13:01 CK BCFC6ED6
CALLED #:xxxxx NUM PLAN: UNKNOWN TON: UNKNOWN
CALLING #:NO DIGIT NUM PLAN: UNKNOWN TON: NATL
DCH 220 UIPE_OMSG CC_SETUP_RESP REF 0000A080 NCALL TOD 11:13:01 CK BCFC6ED7
DCH 220 UIPE_IMSG CC_RELEASE_IND REF 00002080 NCALL TOD 11:13:01 CK BCFC6F35
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.