My VoIP implementation does not display the name of the calling party. The number is displayed, however, the name says "From Unknown Caller". I have validated with the carrier that our PRI circuits are configured to send through this information. How do I configure the gateway so that this information is displayed on the phones. I am running CallManager 4.1.
thank you very much for the info. I made the change and reset the gateway, however I still can't see the calling party name. I get the number but not the name. Any thoughts on what else could be the issue?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...