Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

National Number Prefix - LATA, Intra-LATA numbers

We have found where we can implement national number dialing prefix in service paramaters and adding 91 to the inbound caller-id works for the most part. Our service, however, is on PRI that support both local and LD calls on the same lines.

Our LEC does not allow us to dial 1 for a local or intra-lata call that is not actually LD. Calls that are from local or metro exchanges must be dialed without a 1.

Is there a way to implement this and create an exception for 'local' area codes?

We are on CCM 4.1.3 SR5d

1 REPLY

Re: National Number Prefix - LATA, Intra-LATA numbers

Used your route patterns to do digit stripping for outbound calls. gimme some examples and I will explain how to do it

Please remember to rate useful posts, by clicking on the stars below.

286
Views
0
Helpful
1
Replies
CreatePlease to create content