Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

need an SRST advice

first of all my greetings to everyone who'll see this thread)

I have a common SRST solution: A CUCM 4.2 in central office and remote 3845 with SRST feature with ip-phones on this device registered on the mentioned above CUCM 4.2. In the case of WAN link failure phones are operating in SRST mode.How can I force those phones to register on CME that is collocated with 3845 if WAN link failes?Which commands are used for this purpose(both on CME and SRST routers)?

PS: and one extra question: where is (while operating in SRST mode) the phones' config stored(dn, etc...)? - I ve restored phones config to deafaults - they got their configured on CUCM dns.I've powered off the router - they still got their dns. changed ports of the phones...) <- common curiosity.

3 REPLIES

Re: need an SRST advice

Hi,

The following doc explains how to use CME as SRST:

Configuring SRST Fallback Support

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesrst.html

Cheers,

Martin

Re: need an SRST advice

Hello:

You would need the following basic commands to enable SRST. However please following the recommended guide to design according to your environment

http://www.cisco.com/en/US/docs/voice_ip_comm/cusrst/admin/srst/configuration/guide/srst41/srst41sa.html

call-manager-fallback

ip source-address x.x.x.x port 2000

max-ephones x

max-dn x

HTH

Re: need an SRST advice

That was just exactly what i did - but it didn't work. The reason was in SRST reference on CUCM - there should be IP addess of CME router. now it's working.In the list of Call Managers in the phone config SRST CCM is my CME router.

149
Views
3
Helpful
3
Replies