Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need assistance routing inbound calls from a SIP trunk to different extensions in different partitions

I already have the CUCM system installed, and I have already added the SIP trunk. I need assistance routing different numbers coming in over this SIP trunk to different partitions.

 

Here is a list of patterns coming into the SIP trunk, along with the partitions that these calls need to be routed to:

19722320XXX -> Extensions 2XXX in Partition_A

1972874XXXX -> Extensions XXXX in Partition_B

168222763XX -> Extensions 40XX in Partition_C

19722081000 -> Extension 2000 in Partition_A

19725383191 -> Extension 3000 in Partition_B

18175723897 -> Extension 4000 in Partition_C

 

How do I configure CUCM 10 to route these numbers coming in to the appropriate partitions? All of the above patterns are coming in over the same SIP trunk, but I need help getting these numbers routed correctly to their proper destinations.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Configure the translation

Configure the translation patterns to do that routing, that's all you need.

Turn that data you posted, into TPs.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

Configure the translation

Configure the translation patterns to do that routing, that's all you need.

Turn that data you posted, into TPs.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
48
Views
0
Helpful
1
Replies
CreatePlease login to create content