Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need assistance with FXO ports

I have a 2801 router with a 4 port FXO card in it. I have four POT lines coming into the router. I need some help with sending calls to the ports, can someone post configs on how to have the router send calls from my CCM to the POT lines?

Thanks,

Adam

3 REPLIES

Re: Need assistance with FXO ports

Adam,

The following documents will show you how to configure your gateway to work with CCM using MGCP. One caveat to keep in mind is that you cannot use caller ID with MGCP FXO ports. If you need caller ID, you'll need to configure the gateway to use H.323.

Configuring the Cisco IOS MGCP Gateway

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017787b.shtml

Configure MGCP Gateway and FXO/FXS Ports on a Cisco CallManager Server

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017825e.shtml

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Need assistance with FXO ports

If possible I would prefer to use H323. But If that route doesn't work I will try the MGCP route.

Re: Need assistance with FXO ports

Take a look at the following link for configuring an H.323 gateway for use with CCM.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

Hope this helps. If so, please rate the post.

Brandon

286
Views
1
Helpful
3
Replies
CreatePlease login to create content