I have a task to attached our new Voice Gateay Way (C2951) in our distribution Switch (4507R+E), but my problem is that when I saw this switch configuration I found that right now no one voice gateway is attached in this switch , so my problem is that what i have to do , because I though whenever we require to attach VGW with switch we configure port in swicth as a "TRUNK port" but my question is that what I have to do, either I have to configure that port in swicth as "Swicth port" or as a "Trunk port".
Please help me out ot resolve this problem. i hope I will receive you response very soon.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...