I have 4 FXO port on my router. I want to know whether i can use this 4 FXO port for only receive call(inbound) from outside world or i can use this FXO port to make call to outside( outbound call).pls explain in details
Since you are talking about receiving calls from outside world, I am assuming you are having PSTN termination on the FXO interfaces.
If this is the case then you can have both Incoming and Outgoing calls through the FXO interface.
However if you wan't to restrict Incoming calls [no incoming], that't also possible. It depends on what configuration you do. As far as capability is concerned. Yes you can have both incoming & outgoing calls on the PSTN link terminated on FXO.
Hi Thank u for your reply.I have CCM with MGCP gateway with 4 fxo port. So i can use it for both incoming and outgoing.if it is CCM, H.323 and with 4 FXO port, can i use it for both incoming and out going. if so how to configure it. I have to do it in the dial peers ? pls explain
I am in the same line, configuring MGCP in my 2811 gateway with VIC2-4FXO. My configuration is done, my gateway is registered, i can see the FXO endpoints after issuing 'sh mgcp endpoint', i can make outbound calls. But how can i configure inbound calls?
I have put one of my phone DN in the 'Attendant DN' field. But it always prompts the known unreachable media 'your call cannot be completed.....'
I am attaching the gateway configuration.
Am I missing something? Can anyone guide me please?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...