Need help with removing CME configuration for CM install
I'm planning to test my CallManager install. But first, I plan to backup the IOS configuration on the our production router. Then do a no telephony-service command to remove CME from the router. Input the MGCP commands and test away. My question is, will I be able to restore my saved IOS configuration so that CME is back to original state after testing? Also, is this the best way to remove CME for CM implimentation without messing everything up. Thank you for all your help.
Re: Need help with removing CME configuration for CM install
I've not really tested this, but AFAIK, there is no CME configuration stored in the RAM. So if you copy the previous configuration to the start up config and reload the router after you are done with the testing, CME should be back online without any issue.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...