Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Need quick help to forward all calls

         Hi ,

I need quick help to forward all calls to respctive number.

requirement:I want forward all calls when user pickup receiver

we are connected phone to FXS port in router and router configured as aMGCP gateway.

I given command connection plar under FXS port,and router successfully registed with CUCM,but when user pickup receiver geting fast busy tone.

Is ther any way to configure like connection plar in CUCM.

voice-port 0/2/0

connection plar 92143319630

voice-port 0/2/1

connection plar 92143319630

rtr189#show ccm-manager
MGCP Domain Name: rtr189
Priority        Status                   Host
============================================================
Primary         Registering with CM      X.X.X.X

First Backup    Backup Ready             X.X.X.X

Second Backup   None

Everyone's tags (3)
5 REPLIES
Green

Need quick help to forward all calls

Hi,

As you are using MGCP the IOS config line is ignored.

Take it back out of the config

!

voice-port 0/2/0

no connection plar 92143319630

!

voice-port 0/2/1

no connection plar 92143319630

!

On cucm admin

Device----> Gateway

Find your gateway

Select the end point for 0/2/0

Look down the setting to Porrt Information (Loop or Ground Start)

Type the number you want to call in the Attendant DN box

save

Test and let us know how it goes

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

Need quick help to forward all calls

Hi Alex,

Kindly let me now whether i have to mention port direction inbound r outbound.

Green

Need quick help to forward all calls

Hi,

Direction both ways

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

Need quick help to forward all calls

WE are geting dial tone but not dailing number

Green

Need quick help to forward all calls

Hi,

Sorry my mistake.
The Attendant DN fild is for incoming calls.

Please delete the number from the field.

Can you please try this instead:-
(Names are only suggestions)

1) Create a new Partion
PT-FXS-HOTLINE

2) Create a new CSS
CSS-FXS-HOTLINE
Assign only the Partition
PT-FXS-HOTLINE

3) Create a new Tranlation Pattern
Just put a "." as the actual Translation Pattern
Assign to Partition PT-FXS-HOTLINE
Description FXS-HOTLINE
Calling Search Space - Select a CSS that has access
to the partition that your target dialled number resides
Called Party Transform Mask - YOUR TARGET DN

4) Go to the gateway endpoint
Remove the Attendant DN
Change the CSS to CSS-FXS-HOTLINE


Test again

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
329
Views
0
Helpful
5
Replies
CreatePlease to create content