Need to create a Read-Only user who can access to CDR reports.
I need to create a user in CCM who can access to CDR Reports. I have just create one with the following steps:
1. User Management >> Roles. I create a new rol associated with tha Application: Cisco Call Manager Administration
2. User Management >> User Group. Then I associated the roles create before.
3. User Managemente >> Create a User and associated it with the user group I created before.
I have test it, but it only have access to read only the options from the Cisco Call Manager Administration Application, but the CDR option appears in the
Cisco Unified Serviceability Application. Can I give this user the privileges to access the CDR Report too just to read them? Do i need to create a user associated with the Cisco Unified Serviceability Application? i have done that too, but with this form the user can only see 3 options in the
Cisco Unified Serviceability Application, but not the CDR option.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...