Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Network-clock-select....

Hi guys just a quick query to be honest, after checking my gateways that were configured by another company I have seen a very high amount of slip secs between 33-316.. I have now provided the correct clokcing to the El Controller and they are at 0, but my question is would such a high number of Slip Secs been causing a issue?

Many Thanks in advance.. :D

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Network-clock-select....

Mainly, they cause fax and modem to fail. Human voice is not affected.

Please rate if it helps!

7 REPLIES
Hall of Fame Super Gold

Re: Network-clock-select....

Mainly, they cause fax and modem to fail. Human voice is not affected.

Please rate if it helps!

New Member

Re: Network-clock-select....

Thanks very much :)

Hall of Fame Super Gold

Re: Network-clock-select....

No sweat, thanks for the appreciation and good luck!

New Member

Re: Network-clock-select....

Sorry to be a pain in the backside, and all your help was grately appreciated I just had one query.. Im trying to work out the difference between "clock source line primary" and " network-clock participate" and the ramifications.. of not having either Thank you so much in advance :))

Dan

Hall of Fame Super Gold

Re: Network-clock-select....

Hi, the network-clock commands defines which cards participate in chassis clock system and what are the clock sources to it.

The clock source commands under controlled defined which clock is used for the circuits.

So they are related but each has a specific purpose.

New Member

Re: Network-clock-select....

I see I think I understand, so the network-clock commands specify where the initial clocking comes from as a whole? where as the clock source specifys the actual circuit that the clocking will be provided on..?

Hall of Fame Super Gold

Re: Network-clock-select....

Yes, basically. You set clock source different than default only for special cases.

824
Views
0
Helpful
7
Replies
CreatePlease to create content